centos 6.8命令行下進行pptp撥號

centos 6.8命令行下進行pptp撥號

centos 6.8 命令行下可使用pptpsetup進行pptp撥號

1.先安裝ppp，pptp和pptp-setup三個包

yum install -y ppp pptp pptp-setup

2.使用pptpsetup進行連接

pptpsetup --create VPN名字 --server 服務器IP --username 用戶名 --password 密碼 --encrypt --start          

[root@centos6-8-1 ~]# pptpsetup --create vpn --server 192.168.127.128 --username user --password passwd --encrypt --startUsing interface ppp0Connect: ppp0 <--> /dev/pts/2CHAP authentication succeededMPPE 128-bit stateless compression enabledlocal  IP address 192.168.0.235remote IP address 192.168.0.1

使用ip addr可以看到多了一個接口ppp0:

[root@centos6-8-1 ~]# ip addr1: lo: <LOOPBACK,UP,LOWER_UP> mtu 65536 qdisc noqueue state UNKNOWN     link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00    inet 127.0.0.1/8 scope host lo    inet6 ::1/128 scope host        valid_lft forever preferred_lft forever2: eth0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc pfifo_fast state UP qlen 1000    link/ether 00:0c:29:27:eb:e7 brd ff:ff:ff:ff:ff:ff    inet 192.168.127.129/24 brd 192.168.127.255 scope global eth0    inet6 fe80::20c:29ff:fe27:ebe7/64 scope link        valid_lft forever preferred_lft forever4: ppp0: <POINTOPOINT,MULTICAST,NOARP,UP,LOWER_UP> mtu 1496 qdisc pfifo_fast state UNKNOWN qlen 3    link/ppp     inet 192.168.0.235 peer 192.168.0.1/32 scope global ppp0

3.添加默認路由

route add default dev ppp0

此時已經可以正常使用VPN。

如果想斷開pptp連接,那就直接結束pptp進程

pkill pptp

http://xxxxxx/Linuxjc/1184653.html TechArticle